Remote - ARC Mode

Remote - ARC Mode

Ensure your remote control is in ARC Mode for operation


    • Related Articles

    • How to Activate Fabric Tension (FT) Mode

      If you want to use Ultra-lock function, the Bottom limit MUST be set within the LOCKING ZONE. Jog the weight bar down until you hear the locking pin click into the latch housing and set Bottom  How to Activate Fabric Tension (FT) Mode After doing ...
    • Remote (P2) Button Locations and Functions

      The P2 button is a programming button located on every remote. Typically, it is found on the back of the remote, under the battery cover. Refer to the images below for the P2 location on different control devices  Reflect on the Programming ...
    • Copy Channels From an Existing Remote to a New Remote

      It is Possible to copy channels from an existing remote to a new remote. Note: You will not be able to copy group channels, channel 0 or channel ALL. Only channel with individual shade programmed can be copied to a new remote via steps below in the ...
    • How to Activate Impact Detection Mode

      Impact detection is deactivated by default. It can be activated in all three modes. i.e. Default mode, FT auto mode and FT manual mode.  How to Activate Impact Detection Mode If an obstacle is detected twice in the shade path during downwards ...
    • Solar Powered ARC Wind & Sun Sensor - Pairing Sensor to Motor

      This is the process to pair the Wind and Sun Sensor to an ARC Motor Ensure the wind and sun sensor functionality on the motor is activated prior to pairing the Wind and Sun Sensor You will need to press P2 on wind sensor twice during the process, ...