Solar Powered ARC Wind & Sun Sensor - Pairing Sensor to Motor

Solar Powered ARC Wind & Sun Sensor - Pairing Sensor to Motor

This is the process to pair the Wind and Sun Sensor to an ARC Motor
Ensure the wind and sun sensor functionality on the motor is activated prior to pairing the Wind and Sun Sensor
You will need to press P2 on wind sensor twice during the process, once to wake up the wind sensor and once to pair.
The motor must be paired to a controller prior to pairing the sensor to the motor

How to pair the Wind & Sun Sensor to a Motor




If the pairing is successfully done, the motor can be triggered to move upward by pressing the UP button on the sensor.

Relevant Documentation




    • Related Articles

    • Solar Powered ARC Wind & Sun Sensor - Enabling Sensor Functionality on the Motor

      Prior to pairing the wind and sun sensor with a motor, the sensor functionality on the motor must be enabled.  These are the steps to enable or disable the sensor functionality on Automate Outdoor motors. Only external motors (FT or AX) can be paired ...
    • How to fix jogging/stepping Awning

      If your awning is paired to an AUTOMATE sensor (Motion Sensor or Wind & Sun Sensor). When you go to move your awning out and the awning only extends in a small steps. It is possible the motor has triggered the Safe Guard Technology feature, and is ...
    • How to do a Factory Reset a Motor

      Press and hold the P1 button for approximately 14 seconds to receive 4 jogs and 4 beeps. The P1 button may be a different location depending on the type of motor you have How to Factory Reset a Motor Relevant Documentation Automate Programming ...
    • 5v Li-Ion Motor | Advantages over 12v Li-Ion Motor (1st Gen)

      Rollease Acmeda's 5v Zero Li-Ion motors boasts many advantages over that of its predecessor - the 12v Li-ion motor.  5v Zero Li-Ion Highlights Reduced Motor Head thickness (Smaller Light Gaps) compared to the 12v motor offering. Integrated USB ...
    • Shade Control/Pairing Issues (EL Mode)

      If you're having issues pairing or controlling a shade to your paradigm remote, it is likely in the wrong protocol. It is important to have the remote in ARC mode Try the below to change the remote between Legacy(EL) and ARC protocol. Shade ...