How to Activate Fabric Tension (FT) Mode

How to Activate Fabric Tension (FT) Mode

If you want to use Ultra-lock function, the Bottom limit MUST be set within the LOCKING ZONE.

Jog the weight bar down until you hear the locking pin click into the latch housing and set Bottom 

How to Activate Fabric Tension (FT) Mode




After doing this now we can move on to the next step to ACTIVATE Fabric Tension (FT) Mode.













Relevant Documentation



    • Related Articles

    • How to Activate Impact Detection Mode

      Impact detection is deactivated by default. It can be activated in all three modes. i.e. Default mode, FT auto mode and FT manual mode.  How to Activate Impact Detection Mode If an obstacle is detected twice in the shade path during downwards ...

    • Tilt / Step mode

      How to turn on/off step mode on ARC motors.

    • Remote - ARC Mode

      Ensure your remote control is in ARC Mode for operation

    • Can't Set Limits? How to Lock and Unlock Your Remote

      All Automate control devices can be locked and unlocked. Locking the remote can prevent accidental reprogramming. Ensure the remote(s) are locked once programming is complete. Please refer to your specific control device instructions if you cannot ...

    • Shade Control/Pairing Issues (EL Mode)

      Why is my Paradigm remote not controlling or pairing with my shade? If your Paradigm remote is not pairing with or controlling your shades, it might be in the wrong mode. This article outlines troubleshooting steps to check and resolve this issue. ...