How to Use the 4-Pin Waterproof Connector for ACML Motors and 4CH Controller

How to use the 4pin Waterproof Connector

How to use the 4pin Waterproof Connector

What is the 4pin Waterproof Connector?

The 4pin is a waterproof connector that can be used to connect ACML Motors to the 4CH Controller. When used properly, the 4pin Water Proof Connector is made to keep the connection safe from water, making it perfect for outdoor setups. Essential when extending wiring outdoors, allowing you to splice and connect additional wiring safely when the original wiring isn't long enough.

How do I install the 4pin Waterproof Connector?

1. Disassemble the Connector.

Unscrew and disconnect each part of the connector.


 Male Connector Side


 Female Connector Side


2. Wire the Male Connector.

Connect the Male Side to the Motor wiring.


Tighten the wire connections using a small Philips-head screwdriver.


Notes
Note: Ensure each wire is connected to the correct pin.


3. Wire the Female Connector.

Connect the Female Side to the wiring leading to the 4CH Controller.


Tighten the wire connections using a small Philips-head screwdriver.


Notes
Note: Ensure each wire is connected to the correct pin.



Warning
Note: Confirm that wiring is correct before joining the connector. Each side should match to the same colored wire and pin number.



Neutral
(Pin 1)
Direction 1
(Pin 4)
Direction 2
(Pin 2)
Earth/Ground
(Pin 3)
Australia
BLUE
BLACK
BROWN
GREEN/YELLOW
USA
WHITE
RED
BLACK
GREEN

4. Join the Male and Female connectors.

Once the Motor and blind are installed, tighten the male and female connectors together. 


Relevant Documentation


    • Related Articles

    • How Many People Can Use the App at Once?

      How Many People Can Use the App at Once? The app can be accessed by multiple users from the same account. It is also possible to assign up to 4 Non-Admin users. The maximum is 5 users per account. Relevant Documentation Automate Pulse 2 Programming ...
    • How to Re-connect Your Pulse 2 Hub to WiFi Network via an Apple Device

      Press and hold the P button on the back of the hub. Once it turns green, release. Green indicates that you've cleared out the internet connection. It will then start flashing blue. This indicates that it's ready to pair. SMART MESH NETWORKS Mesh ...
    • How to Re-connect Your Pulse 2 to Wi-Fi Network via an Android Device

      Press and hold the P button on the back of the hub. Once it turns green, release. Green indicates that you've cleared out the internet connection. It will then start flashing blue. This indicates that it's ready to pair. The Pulse 2 Hub can only ...
    • Automate Blinds and Eufy Integration: What You Need to Know

      Our motorized blinds do not currently offer direct integration with Eufy smart devices. Moreover, as of now, there are no third-party services, including IFTTT applets, that facilitate integration of our Automate blinds with Eufy. If you're looking ...
    • 5v Zero Li-Ion Motor | Check Motor Battery Level Status From Remote

      For the utmost convenience, operators can easily determine the motor’s battery level using any of the Automate controller’s one-touch battery-check function. The following applies to 5v motors only How to Check Motor Battery Level Status From Remote ...