Installer Mode - Push Pro

Installer Mode - Push Pro

Installer mode enables you to pair and adjust various settings, bypassing the usual step-by-step on screen instructions.

Press the Menu button and select Settings by pressing the Enter button.

On the Remote Settings screen, Select Installer Mode. 
To exit Installer Mode, press the Back button.

Info
In Installer mode, the menu button is replaced by the P2 button, which is typically used for programming and setup. Here’s a general outline of what the P2 button is used for.
1. Programming Limits: Setting the upper and lower limits for the blinds.
2. Pairing and Unpairing Shades: Associating the remote with specific motorized blinds or removing the association.
3. Shade Settings: Adjusting various settings for your shades.


    • Related Articles

    • Adjusting Motor Speed - Push Pro (Installer Mode)

      To perform the following steps, ensure you are currently in Installer Mode - Push Pro Press P2 on remote (The menu button while in Installer Mode) Increase Speed Decrease Speed
    • Copying Channels - Push Pro (Installer Mode)

      To perform the following steps, ensure you are currently in Installer Mode - Push Pro Set the old remote to the shade channel you wish to copy over Set the new remote to the shade channel you wish to copy the shade onto. Press P2 (Menu in Installer ...
    • Setting/Deleting Favorite Position - Push Pro (Installer Mode)

      To perform the following steps, ensure you are currently in Installer Mode - Push Pro Move Shade to desired position The following steps are used for Adding a Favorite Position, but are also for Deleting a Favorite Position if performed a second time ...
    • Enable/Disable Soft Stop - Push Pro (Installer Mode)

      To perform the following steps, ensure you are currently in Installer Mode - Push Pro Enable Ensure that the motor is at its maximum speed. Then press P2 (The menu button while in Installer Mode) followed by Up twice, allowing the motor to jog ...
    • Remote Settings - Push Pro

      You can customize a variety of settings on your remote control. Press the Menu button on the remote. Select “Remote,” then press the Enter button. Backlight – Choose between 5 levels of brightness Idle – Set the idle time for the remote display to ...