How to Pair/Un-Pair Motor From a Remote
Pairing or Un-pairing a motor from a remote is the same process.
How to Pair or Un-Pair/Remote a Motor From a Remote
Relevant Documentation
Related Articles
Remote (P2) Button Locations and Functions
The P2 button is a programming button located on every remote. Typically, it is found on the back of the remote, under the battery cover. Refer to the images below for the P2 location on different control devices Reflect on the Programming ...5v Zero Li-Ion Motor | Check Motor Battery Level Status From Remote
For the utmost convenience, operators can easily determine the motor’s battery level using any of the Automate controller’s one-touch battery-check function. The following applies to 5v motors only How to Check Motor Battery Level Status From Remote ...Copy Channels From an Existing Remote to a New Remote
It is Possible to copy channels from an existing remote to a new remote. Note: You will not be able to copy group channels, channel 0 or channel ALL. Only channel with individual shade programmed can be copied to a new remote via steps below in the ...How to do a Factory Reset a Motor
Press and hold the P1 button for approximately 14 seconds to receive 4 jogs and 4 beeps. The P1 button may be a different location depending on the type of motor you have How to Factory Reset a Motor Relevant Documentation Automate Programming ...How Do I Setup My Shade/Motor?
This article will show step by step, pairing with a Remote and programming the Motor limits for normal operation. A new motor will have no programming and it will first need to be set up, for it to operate. A motor that has had unexpected ...