What Are the Two Cables at the End of My Motor?
The 12V charging motors have a charge port approximate 6” long with a plug on the end.
The other wire is an antenna and should be extended for optimal signal capture. The cables must be routed so that they cannot get caught up.
Related Articles
How to Factory Reset a Motor
Note: A factory reset will remove all remote pairings, and the shade will need to be set up again. How to Factory Reset a Motorized Shade To perform a factory reset on your motorized shade: Press and hold the P1 button for 14 seconds. (The shade will ...
5v Li-Ion Motor | Advantages over 12v Li-Ion Motor (1st Gen)
Rollease Acmeda's 5v Zero Li-Ion motors boasts many advantages over that of its predecessor - the 12v Li-ion motor. 5v Zero Li-Ion Highlights Reduced Motor Head thickness (Smaller Light Gaps) compared to the 12v motor offering. Integrated USB ...
Motor (P1) Button Locations & Functions
The P1 is found on every motor type. It is used for initial pairing and additional programming steps. Below is the location of the button on various motor models. Tubular Motor - Roller, Roman, or Zebra Shades Cord Lift Motor - Cellular and Honeycomb ...
How Do I Program My Drapery Motor?
It is important to set the programming of the motor after both the motor and track have been assembled. To ensure your shade is ready to be set up from scratch, factory reset it: How to Program a Drapery Motor Relevant Documentation Automate Drapery ...
Battery Motor is Beeping or Stopped Working
Battery Motor is Beeping or Not Working Why is my motorized shade not working/beeping? When the motor's battery is low, it will beep 10 times during use. How do I charge my motorized shade? If the motor stops working, charge it for at least 6 hours ...