What Battery Goes Into My Remote?
The 1-channel and 15-channel handheld remotes take a CR2450 coin cell battery.
Push 5 remote takes a CR2430 coin cell battery.
Other remotes and switches take different batteries as is appropriate.
Remote (P2) Button Locations and Functions
The P2 button is a programming button located on every remote. Typically, it is found on the back of the remote, under the battery cover. Refer to the images below for the P2 location on different control devices Reflect on the Programming ...
5v Zero Li-Ion Motor | Check Motor Battery Level Status From Remote
For the utmost convenience, operators can easily determine the motor’s battery level using any of the Automate controller’s one-touch battery-check function. The following applies to 5v motors only How to Check Motor Battery Level Status From Remote ...
Copy Channels From an Existing Remote to a New Remote
It is Possible to copy channels from an existing remote to a new remote. Note: You will not be able to copy group channels, channel 0 or channel ALL. Only channel with individual shade programmed can be copied to a new remote via steps below in the ...
Paradigm 15 Channel Remote Displaying '18'
If you find that your 15 Channel remote is displaying 18 this can mean two things. Please see below the possibilities for your remote showing 18. Remote Displaying 18 1. The battery in the remote is low / flat and will need to be replaced. 2. The ...
Battery Motor is Beeping or Stopped Working
Battery Motor is Beeping or Not Working When the battery is getting low on the motor, it will start to beep x10 when in use. Please recharge the battery by charging with a compatible charger for your motor. If a Battery motor has stopped working ...