Advanced Programming
Tilt / Step mode
How to turn on/off step mode on ARC motors.
Group channels on Push 15 remote
Push 15 remote has group channels apart from channel 1-15 on which user can group channels on. These group channel can be seen if you scroll pass through channel 15. Group channel are A,B,C,D,E. How to do grouping on these Group channels To do ...
How to fix jogging/stepping Awning
If your awning is paired to an AUTOMATE sensor (Motion Sensor or Wind & Sun Sensor). When you go to move your awning out and the awning only extends in a small steps. It is possible the motor has triggered the Safe Guard Technology feature, and is ...
How to Activate Impact Detection Mode
Impact detection is deactivated by default. It can be activated in all three modes. i.e. Default mode, FT auto mode and FT manual mode. How to Activate Impact Detection Mode If an obstacle is detected twice in the shade path during downwards ...
How to Activate Fabric Tension (FT) Mode
If you want to use Ultra-lock function, the Bottom limit MUST be set within the LOCKING ZONE. Jog the weight bar down until you hear the locking pin click into the latch housing and set Bottom How to Activate Fabric Tension (FT) Mode After doing ...
How to Speed Up or Slow Down Your Shade
Automate motors have 3 adjustable speeds How to Adjust Motor Speed If the the 3rd function does not occur, the motor is already going the slowest or fastest speed depending on the sequence used. Relevant Documentation Automate Li-Ion Programming ...
How Do I Create Group Channels?
Group Channels Using P1 Motor Button Group Channels Using P2 Remote Button How to Control Multiple Shades from One Channel Relevant Documentation Automate Li-Ion Programming Instructions Related Products Automate Remotes
How Do I Set a Favorite Position?
A favorite position can be called upon if set. This allows you to set your shade at a certain percentage and call to it when needed. How to Set a Favorite Position If you'd like to watch a video regarding this, please click here. Relevant ...
How Do I Adjust My Limits?
What are limits? Limits are set during installation—the upper limit determines the highest position, and the bottom limit determines the lowest position of you shade. Over time, you may want to adjust them, if your shade doesn’t fully open or close ...
How Do I Hide Unused Channels?
The Paradigm & Push 15 remote comes default at 15 channels. Inactive channels will not be visible when scrolling through the CH selection. How to Hide Unused Channels Para Automate | Hiding Channels on Paradigm Remote | Instructional Video Relevant ...