Copying Channels - Push Pro (Installer Mode)

To perform the following steps, ensure you are currently in Installer Mode - Push Pro

Set the old remote to the shade channel you wish to copy over

Set the new remote to the shade channel you wish to copy the shade onto.

Press P2 (Menu in Installer Mode) twice on the old remote, allowing the shade to jog each time

Press P2 on the new remote that's on the destination channel

The following are other potential locations for P2 on other models of remotes

• Related Articles

• Copy Channels From an Existing Remote to a New Remote

  It is possible to copy channels from an existing remote to a new remote. Note: Copying channel 0 or channel ALL is not possible. Only channel with individual shade programmed can be copied to a new remote via steps below in the picture. How to Copy ...

• Adjusting Motor Speed - Push Pro (Installer Mode)

  To perform the following steps, ensure you are currently in Installer Mode - Push Pro Press P2 on remote (The menu button while in Installer Mode) Increase Speed Decrease Speed

• Installer Mode - Push Pro

  Installer mode enables you to pair and adjust various settings, bypassing the usual step-by-step on screen instructions. Press the Menu button and select Settings by pressing the Enter button. On the Remote Settings screen, Select Installer Mode. To ...

• Setting/Deleting Favorite Position - Push Pro (Installer Mode)

  To perform the following steps, ensure you are currently in Installer Mode - Push Pro Move Shade to desired position The following steps are used for Adding a Favorite Position, but are also for Deleting a Favorite Position if performed a second time ...

• Enable/Disable Soft Stop - Push Pro (Installer Mode)

  To perform the following steps, ensure you are currently in Installer Mode - Push Pro Enable Ensure that the motor is at its maximum speed. Then press P2 (The menu button while in Installer Mode) followed by Up twice, allowing the motor to jog ...