Enable/Disable Soft Stop - Push Pro (Installer Mode)

To perform the following steps, ensure you are currently in Installer Mode - Push Pro

Enable
Ensure that the motor is at its maximum speed. Then press P2 (The menu button while in Installer Mode) followed by Up twice, allowing the motor to jog between each press.

Disable
Ensure that the motor is at its minimum speed. Then press P2 (The menu button while in Installer Mode) followed by Down twice, allowing the motor to jog between each press.

• Related Articles

• Setting/Deleting Favorite Position - Push Pro (Installer Mode)

  To perform the following steps, ensure you are currently in Installer Mode - Push Pro Move Shade to desired position The following steps are used for Adding a Favorite Position, but are also for Deleting a Favorite Position if performed a second time ...

• Adjusting Motor Speed - Push Pro (Installer Mode)

  To perform the following steps, ensure you are currently in Installer Mode - Push Pro Press P2 on remote (The menu button while in Installer Mode) Increase Speed Decrease Speed

• Copying Channels - Push Pro (Installer Mode)

  To perform the following steps, ensure you are currently in Installer Mode - Push Pro Set the old remote to the shade channel you wish to copy over Set the new remote to the shade channel you wish to copy the shade onto. Press P2 (Menu in Installer ...

• Installer Mode - Push Pro

  Installer mode enables you to pair and adjust various settings, bypassing the usual step-by-step on screen instructions. Press the Menu button and select Settings by pressing the Enter button. On the Remote Settings screen, Select Installer Mode. To ...

• Level-Setting Mode - Push Pro

  This feature allows you to control your shade or group by percentage. Double-click the Stop button to activate the shade Level-Setting mode. Then, use the Up and Down buttons to adjust the desired shade percentage. 100% refers to the shade being ...